LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1191 (Interior Trim And Ornamentation) >> Removal And Installation >> C-Pillar Trim Panel >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

    Vehicles with third row seating 

  1. Position the second row outer seats to the forward position.

    2. Vehicles without third row seating 

  2. Remove the rear seats. For additional information, refer to SEATING .

    3. All vehicles 

  3. Remove the C-pillar lower safety belt anchor bolt.
    • To install, tighten to 40 Nm (30 lb-ft).
  4. Position the door opening weatherstrip aside.
  5. Remove the C-pillar trim panel.
  6. To install, reverse the removal procedure.
    • Be sure the hole on the back of the C-pillar upper trim panel is seated over the upper safety belt anchor bolt.
scientia non olet · About LEMON Manuals