LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1186 (Anti-Lock Brake System Control) >> Removal And Installation >> Wheel Speed Sensor - Rear, 4 Channel >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Disconnect the wheel speed sensor electrical connector.
  3. Disconnect the 3 wheel speed sensor harness pin-type retainers.
  4. Remove the wheel speed sensor bolt.
    • To install, tighten to 27 Nm (20 lb-ft).
  5. Remove the wheel speed sensor and harness assembly.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals