Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .

NOTE: Apply electrical grease to the connector terminals.

Disconnect the wheel speed sensor electrical connector.
Remove the wheel speed sensor bolt.
- To install, tighten to 27 Nm (20 lb-ft).

NOTE: Install a new O-ring.

Remove the wheel speed sensor.
To install, reverse the removal procedure.