Anti-Lock Brake System (ABS) Calibration List (ABS with Stability Assist)
WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The need to calibrate the ABS module is indicated by the stability assist active/fail lamp flashing. The lamp flashes after the DTCs on the calibration list are cleared.
DTC DESCRIPTION CHART
| DTC | Description | Calibration |
|---|---|---|
| C1277 | Steering Wheel Angle 1 and 2 Circuit Failure | YES |
| C1278 | Steering Wheel Angle 1 and 2 Signal Fault | YES |
| C1279 | Yaw Rate Sensor Circuit Failure | YES |
| C1280 | Yaw Rate Sensor Signal Fault | YES |
| C1281 | Lateral Accelerometer Circuit Failure | YES |
| C1282 | Lateral Accelerometer Signal Fault | YES |
| C1285 | Booster Solenoid Circuit Failure | YES |
| C1287 | Booster Pedal Force Switch Circuit Failure | YES |
| C1288 | Brake Pressure Transducer Input Circuit Failure | YES |
| C1440 | Pressure Transducer Input Signal Failure | YES |
| C1516 | Roll Rate Signal Fault | YES |
| C1517 | Roll Rate Sensor Circuit Fault | YES |
| C1730 | Reference Voltage Out of Range (+5 V) | YES |
| C1963 | Stability Control Inhibit Warning | NO |
| C1991 | Module Calibration Failure | YES |
| C1996 | Active Yaw Control Disabled | YES |
| C1998 | Module Calibration Not Complete | NO |
| C2769 | Longitudinal Acceleration Sensor Circuit Failure | YES |
| C2770 | Longitudinal Acceleration Sensor Signal Fault | YES |
| C2777 | Sensor Cluster Bus Failure | YES |
| C2778 | Sensor Cluster Power Supply Failure | YES |