Power Steering Pump - 4.0L Engine: Installation
WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
- Using the special tool, install a new Teflon® seal to the pressure line fitting.
- Install the power steering pump and the 3 bolts.
- Tighten to 25 Nm (18 lb-ft).
- Connect the pressure line-to-pump fitting.
- Tighten to 65 Nm (48 lb-ft).
- Install the power steering pump pulley. For additional information, refer to POWER STEERING PUMP PULLEY - 4.0L ENGINE .
- Install the reservoir-to-pump hose and connect the hose clamp.
- Install the pressure line bracket-to-engine bolt.
- Tighten to 11 Nm (8 lb-ft).
- Fill the power steering system. For additional information, refer to STEERING SYSTEM-GENERAL INFORMATION .