LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1173 (Engine System-General Information) >> General Procedures >> Crankshaft End Play

Crankshaft End Play

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOL CHART

G03878636
 Dial Indicator with Bracketry 100-002 (TOOL-4201-C) or equivalent
  1. Measure the crankshaft end play. Use the special tool to measure crankshaft end play.
  2. Position the crankshaft to the rear of the cylinder block.
  3. Zero the indicator.
  4. Move the crankshaft to the front of the cylinder block. Note and record the crankshaft end play.
    • If crankshaft end play exceeds specifications, install a new crankshaft thrust washer or crankshaft thrust main bearing. Refer to the appropriate ENGINE article for the procedure.
      Fig 1: Measuring Crankshaft End Play
      G03885013Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals