LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1168 (Fuel System And Charging Controls -- 4.0L SOHC) >> Removal And Installation >> Fuel Pump Driver Module (FPDM) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the RH rear quarter trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
    3. NOTE: When installing, make sure the fuel pump driver module (FPDM) electrical connector is connected securely.
  3. Disconnect the FPDM electrical connector.
  4. Remove the bolts and the FPDM.
    • To install, tighten to 10 Nm (89 lb-in).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals