LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1167 (HVAC System - Heating & Ventilation) >> Removal And Installation >> Heater Control Valve - 4.6L (2V) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clamp off the heater hoses at the heater control valve inlet and outlet.
  2. Disconnect the 2 inlet and outlet heater hose clamps.
  3. Remove the heater control valve bolt.
  4. Disconnect the heater control valve vacuum hose.
  5. Remove the heater control valve.
    6. NOTE: Lubricate the coolant hoses with plain water only if needed.
  6. To install, reverse the removal procedure.
  7. Fill the engine cooling system. For additional information, refer to ENGINE COOLING .
scientia non olet · About LEMON Manuals