LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1160 (Front Suspension System -- 4X2) >> Removal And Installation >> Shock Absorber and Spring Assembly >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel and tire assembly. For additional information, refer to WHEELS AND TIRES .
  2. Remove and discard the 3 shock absorber upper mount-to frame nuts.
    • To install, tighten to 30 Nm (20 lb-ft).
  3. Remove and discard the stabilizer bar nut and grommet.
    • To install, tighten to 25 Nm (18 lb-ft).
  4. Remove the stabilizer bar stud.
    5. NOTE: Do not tighten until the installation procedure is complete and the weight of the vehicle is resting on the wheel and tire assemblies.
  5. Remove the shock absorber-to-lower arm bolt.
    • To install, tighten to 350 Nm (258 lb-ft).
  6. Remove and discard the shock absorber-to-lower arm flag nut.
  7. Remove the shock absorber. For additional information, refer to SHOCK ABSORBER AND SPRING ASSEMBLY .
  8. To install, reverse the removal procedure.
    • Always install a new:
      • shock absorber upper mount-to frame nut.
      • stabilizer bar nut and grommet.
      • shock absorber-to-lower arm flag nut.
scientia non olet · About LEMON Manuals