LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1159 (Four-Wheel Drive Systems) >> Removal And Installation >> Mode Select Switch (MSS) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: LHD shown, RHD similar.
  1. Detach the instrument panel center finish panel.
  2. Disconnect the electrical connectors.
  3. Disengage the locking tangs and remove the MSS from the instrument panel center finish panel.
    Fig 1: Disengaging Locking Tangs MSS From Instrument Panel Center Finish Panel
    G03949488Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals