LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1155 (Automatic Transmission) >> In-Vehicle Repair >> Extension Housing Gasket - 4x2 >> Removal

Extension Housing Gasket - 4x2: Removal

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. For additional information, refer to JACKING AND LIFTING .
  2. Remove the driveshaft. For additional information, refer to DRIVESHAFT .
  3. Support the transmission with a suitable jack.
  4. Remove the transmission support insulator nuts.
    Fig 1: Identifying Transmission Support Insulator Nuts
    G03947166Courtesy of FORD MOTOR CO.
  5. Remove the bolts from the transmission support insulator.
    Fig 2: Removing Bolts From Transmission Support Insulator
    G03948671Courtesy of FORD MOTOR CO.
  6. Raise the transmission and remove the transmission support insulator.
    Fig 3: Removing Transmission Support Insulator
    G03948672Courtesy of FORD MOTOR CO.
    7. CAUTION: The parking pawl, parking pawl return spring and parking pawl shaft could fall out during removal of the extension housing.
    Fig 4: Removing Extension Housing
    G03948673Courtesy of FORD MOTOR CO.
  7. Remove the extension housing.
  8. Remove and discard the extension housing gasket.
    Fig 5: Removing Extension Housing Gasket
    G03948674Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals