LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1155 (Automatic Transmission) >> Diagnosis And Testing >> Transmission Drive Cycle Test >> After On-Board Diagnostics

After On-Board Diagnostics

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The vehicle wiring harness, powertrain control module (PCM) and non-transmission sensors may affect transmission operations. Repair these concerns first.

After the on-board diagnostic procedures are completed, repair all DTCs.

Begin with non-transmission related DTCs, then repair any transmission related DTCs. Refer to the DIAGNOSTIC TROUBLE CODE (DTC) CHARTS  for information on condition and symptoms. This chart will be helpful in referring to the correct manual(s) and aids in diagnosing internal transmission concerns and external non-transmission inputs. The pinpoint tests are used in diagnosing transmission electrical concerns. Make sure that the vehicle wiring harness and the PCM are diagnosed as well. The INTRODUCTION -- GASOLINE MODELS article will aid in diagnosing non-transmission electronic components.

scientia non olet · About LEMON Manuals