Drive Mode Procedure for GEAR

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

Follow operating instructions from the scan tool menu screen.

Select "Output State Control."
Select "Trans - Drive Mode."
Select "PIDs" to be monitored.
Monitor all selected PIDs during test.
Select "Parameters - GEAR."
Select Value "1-5."
Press "SEND" to send command.
Reselect Value "1-5."
Press "SEND" to send command.
Select "XXX" to cancel at any time.
Press "SEND."