LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1154 (Engine -- 4.6L (2V)) >> In-Vehicle Repair >> Valve Cover - RH >> Removal

Valve Cover - RH: Removal

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner assembly and the air cleaner outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING .
  2. Disconnect the positive crankcase ventilation (PCV) tube from the PCV valve.
  3. Remove the heater control valve and hose assembly bracket bolt.
  4. Disconnect the vacuum hose connector and position the heater control valve and hose assembly aside.
    Fig 1: Disconnecting Vacuum Hose Connector
    G03947591Courtesy of FORD MOTOR CO.
  5. Remove the 2 A/C tube clamp nuts and position the A/C tube aside.
  6. Disconnect then RH engine wiring harness retainers from the valve cover studs and position the harness aside.
    Fig 2: Disconnecting Then RH Engine Wiring Harness Retainers
    G03947586Courtesy of FORD MOTOR CO.
    7. NOTE: To prevent stretching of the valve cover gasket, loosen the silicone gasket and sealant from the cylinder head by sliding a flat knife between the valve cover gasket and the cylinder head.
  7. Remove the 8 stud bolts, the 3 bolts and the valve cover.
scientia non olet · About LEMON Manuals