LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1153 (Engine -- 4.0L SOHC) >> In-Vehicle Repair >> Hydraulic Lash Adjuster >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the camshaft roller followers. For additional information, refer to CAMSHAFT ROLLER FOLLOWER 
    2. NOTE: Mark each hydraulic lash adjuster to make sure it is returned to its original position.
  2. Remove the hydraulic lash adjusters.
    3. NOTE: The hydraulic lash adjusters must be installed in their original positions.
    NOTE: Lubricate the hydraulic lash adjusters with clean engine oil.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals