LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1153 (Engine -- 4.0L SOHC) >> In-Vehicle Repair >> Hydraulic Chain Tensioner, RH >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the hydraulic chain tensioner
    • To install, tighten to 44 Nm (32 lb-ft).
    2. NOTE: Lubricate the new O-ring seal with clean engine oil.
  2. Remove and discard the O-ring seal.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals