LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1153 (Engine -- 4.0L SOHC) >> In-Vehicle Repair >> Camshafts >> Installation

In-Vehicle Repair: Camshafts: Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

    Both sides 

  1. Install the camshaft.
    2. NOTE: The camshaft bearing caps must be installed in the original positions.
    NOTE: After installing the bolts, check the camshaft for free rotation.
  2. Position the oil supply tube, the camshaft bearing caps and the bolts.
    • Tighten the bolts in the sequence shown in 2 stages.
    • Stage 1: Tighten to 6 Nm (53 lb-in).
    • Stage 2: Tighten to 16 Nm (12 lb-ft).
      Fig 1: Installing Camshaft
      G03947060Courtesy of FORD MOTOR CO.

    3. RH side 

    CAUTION: The camshaft gear must turn freely on the camshaft. DO NOT tighten the bolt at this time.
    Fig 2: Installing Camshaft Sprocket
    G03947061Courtesy of FORD MOTOR CO.
  3. Install the camshaft sprocket and loosely install the bolt.

    4. LH side 

    CAUTION: The camshaft gear must turn freely on the camshaft. DO NOT tighten the bolt at this time.
    Fig 3: Identifying LH Camshaft Sprocket Bolt
    G03913892Courtesy of FORD MOTOR CO.
  4. Install the camshaft sprocket and loosely install the bolt.

    5. Both sides 

  5. The camshafts must be retimed. For additional information, refer to CAMSHAFT TIMING .
  6. Install the cooling fan. For additional information, refer to ENGINE COOLING .
scientia non olet · About LEMON Manuals