LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1152 (Driveshaft) >> Removal And Installation >> Driveshaft Slip Yoke Boot >> Removal

Driveshaft Slip Yoke Boot: Removal

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the driveshaft. For additional information, refer to DRIVESHAFT - FRONT  or DRIVESHAFT - REAR, 4X4 .
  2. Index-mark the driveshaft on both sides of the driveshaft slip yoke boot.
    Fig 1: Identifying Index Mark On Both Sides Of Driveshaft Slip Yoke Boot
    G03944134Courtesy of FORD MOTOR CO.
  3. Remove and discard the driveshaft slip yoke boot clamps.
  4. Separate the driveshaft.
  5. Remove the driveshaft slip yoke boot.
scientia non olet · About LEMON Manuals