LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1152 (Driveshaft) >> Removal And Installation >> Driveshaft Slip Yoke Boot >> Installation

Driveshaft Slip Yoke Boot: Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Grease both ends of the driveshaft.
  1. Position the driveshaft slip yoke boot and the driveshaft slip yoke boot clamps on one end of the driveshaft.
  2. Align the index marks and connect the driveshaft.
    Fig 1: Aligning Index Marks
    G03944134Courtesy of FORD MOTOR CO.
  3. Using the special tool, install the new driveshaft slip yoke boot.
    Fig 2: Installing Driveshaft Slip Yoke Boot
    G03904355Courtesy of FORD MOTOR CO.
  4. Install the driveshaft. For additional information, refer to DRIVESHAFT - FRONT  or DRIVESHAFT - REAR, 4X4 .
scientia non olet · About LEMON Manuals