LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1151 (Front Drive Axle/Differential -- DANA 30) >> Removal And Installation >> Axle Carrier Bushing >> Installation

Axle Carrier Bushing: Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set the new insulator in the housing bore and install the special tools. Align the arrow marks on the special tool with the index mark on the axle housing.
    Fig 1: Aligning Arrow Marks On Special Tool With Index Mark On Axle Housing
    G03944401Courtesy of FORD MOTOR CO.
  2. Draw the insulator into the housing to the measured gap earlier in this procedure.
    Fig 2: Measuring Gap Between Insulator Flange And Axle Housing
    G03944402Courtesy of FORD MOTOR CO.
  3. Install the axle assembly. For additional information, refer to AXLE ASSEMBLY .
scientia non olet · About LEMON Manuals