LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1149 (Rear Disc Brake System) >> Removal And Installation >> Rear Brake Pads >> Removal

Rear Brake Pads: Removal

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check the brake fluid level in the brake master cylinder reservoir.
    • If required, remove fluid until the brake master cylinder reservoir is half full.
  2. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
    3. CAUTION: Do not pry in caliper sight hole to retract pistons as this can damage the pistons and boots.
    CAUTION: Do not allow the brake caliper to hang from the flexible hose. Us a suitable tool to support the brake caliper.
  3. Remove the 2 brake caliper bolts and position the caliper aside.
    4. CAUTION: Install a new pad if it is worn past the specification.
  4. Remove the pads and spring clips.
    • Discard the spring clips.
scientia non olet · About LEMON Manuals