Rear Brake Pads: Installation
WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
- Install the spring clips and brake pads.
- Use a suitable tool to push the brake caliper pistons into the caliper bore.
- Position the brake caliper and install the brake caliper bolts.
- Tighten to 32 Nm (24 lb-ft).
- Fill the brake master cylinder reservoir with clean brake fluid.
- Test the brakes for normal operation.
NOTE:
One brake disc pad kit contains the linings required for both sides.