LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1148 (Front Disc Brake System) >> Removal And Installation >> Front Brake Caliper Anchor Plate >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Mountaineer and 2005 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the brake pads. For additional information, refer to BRAKE PADS .
  2. Remove and discard the 2 brake caliper anchor plate bolts and remove the brake caliper anchor plate.
    • To install, tighten to 136 Nm (100 lb-ft).
  3. To install, reverse the removal procedure.
    • Lubricate the brake caliper guide and locator pins with silicone grease.
scientia non olet · About LEMON Manuals