LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1136 (Warning System) >> General Procedures >> Safety Belt Minder Deactivating/Activating >> Deactivating/Activating

Safety Belt Minder Deactivating/Activating: Deactivating/Activating

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to the RUN (or ON) position. (Do not start the engine.)
  2. Wait approximately 1 minute until the safety belt warning indicator turns off.
    3. NOTE: Step 3 must be completed within 50 seconds after the safety belt warning indicator turns off.
  3. To disable the seating position, buckle then unbuckle the safety belt 9 times, ending in the unbuckled state.
    • After Step 3, the safety belt warning indicator illuminates for 3 seconds.
  4. Within 10 seconds of the safety belt warning indicator turning on, buckle then unbuckle the safety belt.
    • This disables the belt minder feature for that seating position, if it is currently enabled. As confirmation, the restraint system warning indicator flashes 4 times per second for 3 seconds.
    • This enables the belt minder feature for that seating position, if it is currently disabled. As confirmation, the restraint system warning indicator flashes 4 times per second for 3 seconds, followed by 3 seconds with the light off, then followed by the restraint system warning indicator flashing 4 times per second for 3 seconds again.
scientia non olet · About LEMON Manuals