Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.

Remove the wiper pivot arms and cowl panel grille. For additional information, refer to WIPER PIVOT ARM - FRONT and FRONT END BODY PANELS .
Remove the wiper mounting arm and wiper pivot shaft assembly.
1. Disconnect the electrical connector.
2. Remove the 3 bolts.
  - To install, tighten to 8 Nm (71 lb-in).
    
    Fig 1: Removing Wiper Mounting Arm And Wiper Pivot Shaft Assembly
    Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
- Adjust the wiper pivot arms. For additional information, refer to WINDSHIELD WIPER BLADE AND PIVOT ARM ADJUSTMENT .