Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.

Remove the wiper mounting arm and pivot shaft assembly. For additional information, refer to WIPER MOUNTING ARM AND PIVOT SHAFT .
Remove the windshield motor.
1. Disconnect the wiper pivot arm linkage.
2. Remove the 3 bolts.
  - To install, tighten to 15 Nm (11 lb-ft).
    
    Fig 1: Removing Windshield Motor
    Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.