Side Crash Sensor: Installation
WARNING: This page is about a different car, the 2002 Lincoln Blackwood. However, it is still accessible from the selected car via links, so may be relevant.
- Connect side crash sensor electrical connector. Position side crash sensor in vehicle and install mounting bolts. Tighten crash sensor mounting bolts to specification. See TORQUE SPECIFICATIONS . Reposition carpet. Connect negative battery cable. With air bag simulators installed at all deployable air bag system devices, perform system operation check. See SYSTEM OPERATION CHECK .
- Disconnect negative battery cable. Wait at least one minute for back-up power supply to deplete stored energy. To complete installation, reverse removal procedure. Activate air bag system. See ACTIVATING SYSTEM under DISABLING & ACTIVATING AIR BAG SYSTEM.