LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1108 (Exterior Lighting System) >> Removal And Installation >> Ballast >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Make sure the headlamp switch and ignition switch are in the OFF position.
  1. Remove the headlamp assembly. For additional information, refer to HEADLAMP ASSEMBLY - FIVE HUNDRED, MONTEGO .
  2. Remove the 3 screws and the headlamp bracket.
  3. Remove the 3 screws and the ballast.
    • Disconnect the electrical connectors.
  4. To install, reverse the removal procedure.