LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Engine Controls - Removal, Overhaul & Installation - Gasoline) >> Fuel System >> Fuel Rails & Injectors >> Installation

Fuel Rails & Injectors: Installation

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2000 Mercury Villager, 2000 Mercury Mountaineer, 2000 Lincoln Navigator, 2000 Ford Windstar, and 2000 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse removal procedure. Lubricate NEW "O" rings with light oil. Install 2 "O" rings onto each injector (one per injector if injectors were not removed from fuel rail). DO NOT use silicone grease.
  2. Install fuel rail and injectors in intake manifold. Ensure injectors are seated. Secure fuel manifold assembly with retaining bolts. Connect injector wiring harness.
NOTE: On Villager, some fuel injectors can be accessed and removed without removing fuel rail.


Replace injector "O" rings, grommet and insulator. Lubricate NEW injector "O" rings with light oil. DO NOT use silicone grease. Carefully install fuel rail and tighten injector caps to specification. See TORQUE SPECIFICATIONS . To complete installation, reverse removal procedure.



Lubricate NEW injector "O" rings with light oil. DO NOT use silicone grease. Carefully install fuel supply manifold and injectors into lower manifold, one side at a time. To complete installation, reverse removal procedure.

scientia non olet · About LEMON Manuals