LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1099 (Automatic Transmission - CVT) >> Diagnosis And Testing >> Pinpoint Tests - Non OSC Equipped Vehicle >> Pinpoint Tests >> Pinpoint Test D: Torque Converter Clutch

Pinpoint Test D: Torque Converter Clutch

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. D1 ELECTRONIC DIAGNOSTICS 
    • Check to make sure the transaxle harness connector is fully seated, pins are fully engaged in the connector and in good condition before proceeding.
    • Connect the scan tool.
    • Drive the vehicle with a steady speed up to and above 24 km/h (15 mph).
    • Monitor PID: (PCE/TCC).
    • The TCC commanded pressure should be greater than 400 kPa (44 psi) and the turbine shaft speed should be equal to engine speed.
    • Is the lockup commanded pressure greater than 400 kPa (44 psi) and the turbine speed equal to engine speed? 
    1. Yes  : CLEAR all DTCs. ROAD TEST to verify if concern is still present. Concern could be intermittent.
    2. No  : INSTALL a new torque converter.
scientia non olet · About LEMON Manuals