LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1097 (Anti-Lock Brake System) >> Removal And Installation >> Wheel Speed Sensor - Front >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the wheel speed sensor electrical connector.
  3. Remove the 2 scrivets and position aside the fender splash shield.
  4. Remove the wheel speed sensor harness pin-type retainer.
  5. Remove the 2 wheel speed sensor harness retainers.
  6. Remove the bolt and the wheel speed sensor.
    • To install, tighten to 8 Nm (71 lb-in).
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals