Diagnostics Disabling Procedure (Seats Removed)
WARNING: This page is about a different car, the 2002 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The following diagnostics deactivation procedure should not be used when replacing air bag system components. If replacing air bag system components, see COMPONENT REPLACEMENT DISABLING PROCEDURE
.
This procedure should only be used when performing air bag system diagnostics or repairs.
- Record pre-set radio frequencies for reprogramming, if equipped. Disconnect negative battery cable. Wait at least one minute for back-up power supply to deplete stored energy.
- Remove steering wheel access cover. Disconnect driver-side air bag module connector. Install Air Bag Simulator (418-F468) to vehicle harness side of clockspring electrical connector (in place of air bag). See AIR BAG SIMULATOR .
- Open glove box past its stops. Through glove box opening, disconnect passenger-side air bag module connector. Connect Air Bag Simulator (418-F468) to vehicle harness side of passenger-side air bag vehicle connector (in place of air bag). Remove affected front seat(s). See FRONT SEAT . Disconnect side air bag module connector(s) on any seat(s) remaining in vehicle.
- On models equipped with side air bags, install Air Bag Simulators (418-F470) on vehicle harness side of right and left side air bag module connectors. On all models, remove left seat belt buckle pretensioner electrical connector from bracket under front seat. Disconnect left pretensioner electrical connector. Install Air Bag Simulator (418-F468) to vehicle harness side of left pretensioner electrical connector. Repeat procedure for right pretensioner. Reconnect negative battery cable.