LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 109 (Supplemental Inflatable Restraint System) >> Disabling & Activating Air Bag System >> Activating System >> General Activating Procedure (Seats Installed)

General Activating Procedure (Seats Installed)

WARNING: This page is about a different car, the 2002 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable. Wait at least one minute for back-up power supply to deplete stored energy. Remove air bag simulators from left and right front seat belt pretensioner harness connectors and reconnect connectors. Install pretensioner electrical connectors on retaining brackets.
  2. On models equipped with side air bags, remove air bag simulators from left and right side air bag module harness connectors and reconnect connectors. On all models, remove air bag simulator from passenger-side air bag module harness connector. Close glove box.
  3. Remove air bag simulator from clockspring harness connector and reconnect connectors. Install steering wheel access cover. Reconnect negative battery cable. With all air bags installed and connected, perform system operation check. See SYSTEM OPERATION CHECK  under . Reprogram pre-set radio frequencies and set clock.
scientia non olet · About LEMON Manuals