LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1085 (Steering Column) >> Removal And Installation >> Steering Wheel >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the steering wheel in the straight-ahead position and remove the ignition key.
  2. Remove the driver air bag module. For additional information, refer to REMOVAL .
  3. Remove and discard the steering wheel bolt.
    • To install, tighten to 40 Nm (30 lb-ft).
  4. Remove the steering wheel.
    • Route the 2 driver air bag module electrical connectors through the steering wheel.
  5. To install, reverse the removal procedure.
    • Install the driver air bag module. For additional information, refer to INSTALLATION .
scientia non olet · About LEMON Manuals