LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1079 (Engine System-General Information) >> General Procedures >> Exhaust Manifold Cleaning and Inspection >> Special Tool(s)

Special Tool(s)

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOL SPECIFICATION

G03901974
 Straight Edge 303-D039 (D83L-4201-A) or equivalent
  1. Clean the exhaust manifold using a suitable solvent. Use a plastic scraping tool to clean the gasket sealing surfaces.
    2. NOTE: New exhaust manifold gaskets, nuts and/or bolts must be installed when an exhaust manifold is serviced.
    Fig 1: Checking Exhaust Manifold Sealing Surface For Warpage
    G03913726Courtesy of FORD MOTOR CO.
  2. Using the special tool (or a precision straight edge) and a feeler gauge, check the exhaust manifold sealing surface for warpage. If the warpage is greater than 0.76 mm (0.0299 in), install a new exhaust manifold.
scientia non olet · About LEMON Manuals