LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1077 (Engine) >> In-Vehicle Repair >> Oil Level Indicator and Tube >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the oil level indicator.
  2. Remove the stud bolt and the oil level indicator tube.
    • Remove and discard the O-ring seal.
    • To install, tighten to 9 Nm (80 lb-in).
    3. NOTE: Install a new O-ring seal and lubricate with clean engine oil.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals