Removal and Installation
WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
When carrying out maintenance on the starting system, be aware that the heavy gauge leads are connected directly to the battery. Make sure the protective caps are in place when maintenance is completed.
- Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
- Remove the air cleaner assembly. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .
- Remove the starter solenoid terminal cover.
- Remove the nuts and position the starter solenoid cables aside.
- To install, tighten the large nut to 12 Nm (9 lb-ft).
- To install, tighten the small nut to 6 Nm (53 lb-in).
- Remove the bolts and the starter motor.
- To install, tighten to 25 Nm (18 lb-ft).
- To install, reverse the removal procedure.