LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 107 (Air Bag Restraint Systems) >> Disabling & Activating Air Bag System >> Disabling System >> Diagnostics Disabling Procedure

Diagnostics Disabling Procedure

WARNING: This page is about a different car, the 2002 Ford RV Cutaway, 2002 Ford Econoline, 2002 Ford E550 Super Duty, 2002 Ford E450 Super Duty, and 2002 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Record pre-set radio frequencies for reprogramming, if equipped. Disconnect battery(s). Follow appropriate procedure. Wait at least one minute for back-up power supply to deplete stored energy.
  2. Remove driver-side air bag module. See DRIVER-SIDE AIR BAG MODULE  under REMOVAL & INSTALLATION. Connect Air Bag Simulator (418-F088/105-R0012) to clockspring connector at top of steering column (in place of air bag). See AIR BAG SIMULATOR .
  3. On models equipped with passenger-side air bag, remove right-side lower instrument panel finish panel, reinforcement and reinforcement bracket. Looking up between interior engine cover and air bag module, locate and disconnect passenger-side air bag module harness connector. Connect Air Bag Simulator (418-F088/105-R0012) to harness side of connector. On all models, reconnect battery(s).
scientia non olet · About LEMON Manuals