LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 106 (Supplemental Inflatable Restraint System - F150 Pickup) >> Disabling & Activating Air Bag System >> Activating System >> General Activating Procedure (Seats Installed)

General Activating Procedure (Seats Installed)

WARNING: This page is about a different car, the 2002 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable. Wait at least one minute for back-up power supply to deplete stored energy. Remove air bag simulators from right and left pretensioner harness connectors and reconnect connectors. Tighten seat belt guide nut to specification. See TORQUE SPECIFICATIONS  . Install trim panels and components removed to access seat belt pretensioners.
  2. Remove air bag simulator from passenger-side air bag module harness connector. Install passenger-side air bag module. Remove air bag simulator from upper clockspring connector. Install driver-side air bag module. Reconnect negative battery cable. Perform system operation check. See SYSTEM OPERATION CHECK  . Reprogram pre-set radio frequencies and set clock.
scientia non olet · About LEMON Manuals