LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1054 (Safety Belt System -- F150 Pickup) >> Removal And Installation >> Safety Belt Buckle - Front, Center >> All vehicles

All vehicles

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front 20 percent seat. For additional information, REFER to SEATING .

    Regular cab safety belt mini-buckle 

  2. Remove the LH seat side trim panel screw and trim panel.
  3. Remove the bolt and the safety belt mini-buckle.
    • To install, tighten to 55 Nm (41 lb-ft).
    • The anti-rotation tab must be correctly aligned for correct installation.

    Super Cab and Super Crew safety belt buckle

  4. Remove the LH seat side trim panel screw and trim panel.
  5. Remove the safety belt buckle bolt and safety belt buckle.
    • To install, tighten to 55 Nm (41 lb-ft).
    • The anti-rotation tab must be correctly aligned for correct installation.

    Regular cab safety belt buckle 

  6. Remove the RH upper seat side trim panel screw and trim panel.
  7. Remove the RH lower seat side trim panel screw and trim panel.
  8. Remove the safety belt buckle bolt and safety belt buckle.
    • To install, tighten to 55 Nm (41 lb-ft).
    • The anti-rotation tab must be correctly aligned for correct installation.

    All vehicles 

  9. To install, reverse the removal procedure.
  10. Check the active restraint system for correct operation. For additional information, refer to SAFETY BELT SYSTEM .
scientia non olet · About LEMON Manuals