LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Supplemental Inflatable Restraint System) >> Disabling & Activating Air Bag System >> Disabling System >> For Diagnostics (Driver & Passenger AIR Bags)

For Diagnostics (Driver & Passenger AIR Bags)

WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Record pre-set radio frequencies for reprogramming, if equipped. Disconnect negative battery cable. Wait at least one minute for back-up power supply to deplete stored energy.
  2. Remove driver-side air bag module. See DRIVER-SIDE AIR BAG MODULE  under REMOVAL & INSTALLATION. Connect Air Bag Simulator (418-F088/105-R0012) to clockspring connector at top of steering column (in place of air bag). See AIR BAG SIMULATOR  .
  3. Remove passenger-side air bag module. See PASSENGER-SIDE AIR BAG MODULE  under REMOVAL & INSTALLATION. Connect air bag simulator to passenger-side air bag vehicle harness connector (in place of air bag). Connect negative battery cable.
scientia non olet · About LEMON Manuals