LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Supplemental Inflatable Restraint System) >> Disabling & Activating Air Bag System >> Activating System >> For Component Replacement (Driver & Passenger AIR Bags)

For Component Replacement (Driver & Passenger AIR Bags)

WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery cable. Wait at least one minute for back-up power supply to deplete stored energy. Remove air bag simulator from passenger-side air bag module harness connector and reconnect connectors. Close glove box door.
  2. Remove air bag simulator from clockspring harness connector and reconnect connectors. Install steering column opening finish panel reinforcement and finish panel. Tighten finish panel reinforcement bolts to specification. See TORQUE SPECIFICATIONS  . Install hood release handle.
  3. Connect negative battery cable. Perform system operation check. See SYSTEM OPERATION CHECK  . Reprogram pre-set radio frequencies and set clock.
scientia non olet · About LEMON Manuals