LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1046 (Bumper System -- F150 Pickup) >> Removal And Installation >> Front Bumper >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the hood release retaining bolt.
  2. Position aside the hood release assembly.
    • Disconnect the hood release cable routing retainer.
  3. Remove the 3 front bumper cover-to-front bumper bolts.
  4. Remove the hood-over slam bumper bolts.
  5. Remove the hood-over slam bumpers.
  6. Remove the 3 air dam pin-type retainers.
  7. If equipped, disconnect the fog lamp electrical connectors.
  8. Remove the 4 bumper mounting bracket-to-front bumper nuts.
    • To install, tighten to 115 Nm (85 lb-ft).
  9. Remove the front bumper.
  10. To install, reverse the removal procedure.
    • Transfer components as necessary.
scientia non olet · About LEMON Manuals