LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1038 (Seat System -- F150 Pickup) >> Removal And Installation >> Seat - Front >> Removal

Seat - Front: Removal

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
WARNING: To reduce the risk of personal injury, do not use any memory saver devices.
NOTE: If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered.
NOTE: The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
NOTE: Driver seat shown, passenger seat similar.
  1. Move the seat fully rearward.
  2. Remove the 2 front seat track-to-floor front bolts.
  3. Move the seat to the most forward position.
  4. Depower the SRS. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM SRS DEPOWERING AND REPOWERING .
  5. Remove the 2 front seat track-to-floor rear bolts.
    6. NOTE: Additional component connectors may exist due to vehicle options.
  6. Disconnect the electrical connector(s).
  7. Remove the seat from the vehicle.
scientia non olet · About LEMON Manuals