LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1038 (Seat System -- F150 Pickup) >> Disassembly And Assembly >> Seat Backrest - Front, 20 Percent >> Disassembly and Assembly

Disassembly and Assembly

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Due to locator pin location on the riser frame, 20 percent seat riser frames will not interchange between regular cab vehicles and SuperCab/SuperCrew vehicles.

    All Seats 

  1. Remove the 20 percent seat. For additional information, refer to SEAT - FRONT, 20 PERCENT .
  2. Remove the LH side shield pin-type retainer, screw and shield.
  3. Remove the RH upper side shield screw and shield.
  4. Remove the RH lower side shield screw and shield.
  5. Seats With Storage Armrest 

  6. Remove the cupholder assembly screws.
    • Disconnect the electrical connector and remove the cupholder assembly.
  7. All Seats 

  8. Remove the safety belt buckle or safety belt mini-buckle bolt and the buckle/mini-buckle on the LH side.
    • To install, tighten to 55 Nm (41 lb-ft).
  9. Remove the lap safety belt or safety belt buckle bolt and the safety belt/buckle on the RH side.
    • To install, tighten to 55 Nm (41 lb-ft).
  10. Remove the LH backrest bracket pivot bolt and pivot bolt bushing.
    • To install, tighten to 35 Nm (26 lb-ft). Seats with storage armrest
  11. Remove the backrest stop bolt.
  12. All Seats 

  13. Remove the 2 RH upper adjustable backrest bracket bolts and the adjustable backrest.
    • To install, tighten to 35 Nm (26 lb-ft).
  14. Remove the RH lower adjustable backrest bracket screw, 2 bolts and the adjustable backrest bracket.
  15. Remove the LH lower backrest pivot bracket screw, 2 bolts and the backrest pivot bracket.
  16. Seats Without Storage Armrest 

  17. Unzip the armrest trim cover zipper, peal the trim cover back and remove the hog rings and the trim cover.
  18. All Seats 

  19. To assemble, reverse the disassembly procedure.