LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1038 (Seat System -- F150 Pickup) >> Diagnosis And Testing >> Seats >> Pinpoint Tests >> Pinpoint Test B: The Power Seat Moves But Is Noisy >> Pinpoint Test B: The Power Seat Moves Buy Is Noisy

Pinpoint Test B: The Power Seat Moves Buy Is Noisy

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. B1 CHECK THE TRACK ALIGNMENT 
    WARNING: The restraint system diagnostic tool is for restraint system service only. Remove from vehicle prior to road use. Failure to remove could result in injury and possible violation of vehicle safety standards.
    NOTE: If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered. REFER to SUPPLEMENTAL RESTRAINT SYSTEM SRS DEPOWERING AND REPOWERING .
    NOTE: The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
    NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
    • Key in OFF position.
    • Depower the SRS. Refer to SUPPLEMENTAL RESTRAINT SYSTEM SRS DEPOWERING AND REPOWERING .
    • Disconnect the affected seat safety belt buckle pretensioner C3201 (driver) or C3202 (passenger).
    • Connect restraint system diagnostic tool 418-F395 to the affected seat safety belt buckle pretensioner C3201 (driver) or C3202 (passenger).
      • WARNING: Be sure that nobody is in the vehicle and that there is nothing blocking or set in front of any air bag module when the battery ground cable is connected.
    • Connect the battery ground cable.
    • Check the alignment of the track to the floor and the track to the seat.
    • Is the track out of alignment? 
    • Yes  : ALIGN the track to the seat and the floor. TEST the system for normal operation. DISCONNECT the battery ground cable. DISCONNECT the restraint system diagnostic tool from driver seat safety belt buckle pretensioner C3201 or passenger seat safety belt buckle pretensioner C3202. CONNECT driver seat safety belt buckle pretensioner C3201 or passenger seat safety belt buckle pretensioner C3202. REPOWER the supplemental restraint system (SRS). REFER to SUPPLEMENTAL RESTRAINT SYSTEM .
    • No  : INSTALL a new seat track part. TEST the system for normal operation. DISCONNECT the battery ground cable. DISCONNECT the restraint system diagnostic tool from driver seat safety belt buckle pretensioner C3201 or passenger seat safety belt buckle pretensioner C3202. CONNECT driver seat safety belt buckle pretensioner C3201 or passenger seat safety belt buckle pretensioner C3202. REPOWER the supplemental restraint system (SRS). REFER to SUPPLEMENTAL RESTRAINT SYSTEM SRS DEPOWERING AND REPOWERING .
scientia non olet · About LEMON Manuals