LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1035 (Cruise Control System -- F150 Pickup) >> Removal And Installation >> Speed Control Deactivator Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Do not press the brake pedal when removing or installing the speed control deactivator switch or damage to the switch will occur.
  1. Disconnect the speed control deactivator switch electrical connector.
  2. Rotate the speed control deactivator switch counterclockwise 45 degrees and remove it.
    3. NOTE: The speed control deactivator switch is self-adjusting. Do not press the brake pedal during installation. Initial installation of the speed control deactivator switch allows for one adjustment. If additional adjustments are necessary, install a new speed control deactivator switch.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals