LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1031 (Transfer Case -- F150 Pickup) >> In-Vehicle Repair >> Transfer Case Rear Output Shaft Seal >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
    2. NOTE: Index-mark the rear driveshaft yoke and pinion flange to maintain initial driveshaft balance during installation.
  2. Remove the rear driveshaft. For additional information, refer to DRIVESHAFT .
  3. Using a suitable tool, remove the transfer case rear output shaft seal.
    Fig 1: Removing Transfer Case Rear Output Shaft Seal
    G03964831Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
    • Using the special tool, install the oil seal.
    Fig 2: Installing Oil Seal Using Special Tool
    G03964832Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals