LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Engine Controls - Removal, Overhaul & Installation - ECONOLINE - NGV) >> Ignition Systems >> Camshaft Position Sensor >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2002 Ford Econoline and 2002 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Camshaft Position (CMP) sensor is located at front of left cylinder head. Disconnect negative battery cable. Disconnect CMP sensor connector. Remove CMP sensor mounting bolts. Remove CMP sensor. To install, reverse removal procedure. Tighten CMP sensor mounting bolts to specification. See TORQUE SPECIFICATIONS .

scientia non olet · About LEMON Manuals