LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1026 (Anti-Theft System -- F150 Pickup) >> Removal And Installation >> Passive Anti-Theft System (PATS) Transceiver >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering wheel. For additional information, refer to STEERING COLUMN .
  2. Remove the 2 bolts and the lower steering column shroud.
    3. NOTE: Vehicles with steering column shift shown, floor console shift is similar.
  3. Remove the ignition cylinder cover.
  4. Disconnect the PATS transceiver electrical connector.
  5. Remove the screw and the PATS transceiver.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals